Whirlpool TEP 649 L Bedienungsanleitung PDF herunterladen (Seite 20)

 The glue applied on the gaskets leaves traces of

grease on the glass. Before using the appliance, we

recommend you remove these with a special non-

abrasive cleaning product. During the first few hours

of use there may be a smell of rubber which will

disappear very quickly.

 A few seconds after the hob is connected to the

electricity supply, a buzzer will sound. The hob may

now be switched on.

 The position of the corresponding gas burner is

shown on every knob.

Gas burners

Each burner can be adjusted to one of the following

settings using the corresponding control knob:

 Off

Maximum

Minimum

To light one of the burners, hold a lit match or lighter

near the burner and, at the same time, press down

and turn the corresponding knob anti-clockwise until

it reaches the maximum setting.

For models fitted with a safety device, the knob

should be held down for approximately 2-3 seconds,

until the automatic device keeping the flame alight

has heated up.

Some models are equipped with an ignition device

which is built into the knob. To light the selected

burner, press down and turn the corresponding

knob, then turn it an anti-clockwise direction until it

reaches the maximum setting. Keep it pressed

down until the burner has been lit successfully.

 If the burner flame is accidentally extinguished,

shut off the control knob and wait for at least one

minute before attempting to light the burner again.

To switch off the burner, turn the knob in a clockwise

direction until it stops (when it reaches the 



position).

Switching on the hob

To switch the hob on, press and hold the button

for approximately one second.

Switching on the cooking zones

The power of each cooking zone is controlled by a

device consisting of two buttons.

 Press the

button to activate the hotplate, then

set the power to the desired level using the

and buttons.

 To set the power to maximum, press and hold the

button briefly.

Booster function

The booster function for the rear cooking zones may

be used to shorten heating-up times. It is activated

by pressing the

oost erbbooostost erer

button. The letter P appears

on the power indicator display. This function boosts

the power of the corresponding zone to 3000 W.

It stops automatically after 4 minutes. While the

booster for one of the rear zones is active, the

maximum power of the front zones is limited to 600

W (e.g. if the rear left hotplate booster is activated,

the power of the front left hotplate decreases).

Switching off the cooking zones

 Press the button; the power of the cooking

zone will progressively decrease until it is

switched off.

 Alternatively, the

and buttons may be

pressed simultaneously. This immediately returns

the power setting to 0 and the cooking zone

switches off.

Programming the cooking duration

 All the cooking zones may be programmed for a

length of time between 1 and 99 minutes.

1. Select the cooking zone using the corresponding

selector button.

2. Adjust the temperature.

3. Press the

programming button.

3. Set the cooking time using the

and

buttons.

Start-up and use

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare

Whirlpool TEP 649 L Bedienungsanleitung Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Whirlpool TEP 649 L