Whirlpool KHMF 9010/I Bedienungsanleitung PDF herunterladen (Seite 12)

Gas connection

The electrical connections must comply with local

standards.

• Information on the voltage and power absorbed are shown on

the serial no. plaque.

• The appliance must be earthed by law.

• When installing the appliance you must make sure there is a

multipolar switch with contact opening equal or greater than

3mm.

• If necessary, the power cable must be replaced exclusively

with a cable that is identical to the original one provided

(H05V2V2-F T90°C or H05RR-F type). Please contact the

Customer Care Centre.

• Do not use extension cables.

• The manufacturer declines all responsibility for damage

to persons, pets or goods as a result of failure to comply

with the regulations above.

Electrical connection

Earth

(yellow/green)

The gas mains system must comply with local

regulations.

• The paragraph on “national legislation

reference” shows the local legislation specific to

the country of destination.

• Should there be no information regarding your

country of interest, ask for further details from

the installer.

• The connection of the hob to the gas mains

network or gas cylinder must be done using a

rigid copper or steel pipe with parts that

comply with local standards, or using a flexible

stainless steel pipe with continuous surfaces that

comply with local standards. The flexible

metallic pipe should be no longer than 2 linear

metres.

• Before connecting the pipe with the rubber part

(A), insert the seal (B) provided, that complies

with EN 549.

Warning: if you use a stainless steel flexible pipe, it

must be installed in such a way that it does not

come into contact with moving cabinetry like

drawers or kitchen cupboards and passes at a point

free of obstacles where it can be examined in its

entirety.

• After connecting to the gas mains, use soap and

water to check there are no leaks.

FOR BELGIUM ONLY: It is necessary to replace

the elbow connection (A) on the appliance, with

the one supplied.

Important: if a stainless steel hose is used, it

must be installed so as not to touch any

mobile part of the furniture. It must pass

through an area where there are no

obstructions and where it is possible to

inspect it on all its length. After connection to

the gas supply, check for leaks with soapy

water.

Attention: Should you experience difficulty in

turning the burners knobs, please contact the

After Sales Service for the replacement of the

burner tap.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Whirlpool KHMF 9010/I Bedienungsanleitung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Whirlpool KHMF 9010/I