Whirlpool HOB 461 S Bedienungsanleitung PDF herunterladen (Seite 22)

Technical information for

the installer

The appliance must be installed by a qualified

engineer following the manufacturer’s

instructions and in compliance with local

regulations in force.

To fit the hob into the unit remember that:

• Inside the unit there must be a space of at

least 30 mm between the bottom of the hob

and the top of an appliance or bracket.

• Any wall to the side and above the hob must

be at least 100 mm away.

• The wall behind the hob must be at least

50 mm away.

• When there is a wall unit or hood above the

hob there must be at least 650 mm between

the hob and the unit or hood.

• The coatings of the walls of the unit or

appliances near the hob must be heat

resistant (“Y” protection against heating in

compliance with standards EN 60335-2 6).

Do not install the hob near inflammable

materials (e.g. curtains).

Before installing the hob, remove the protective

film.

This hob can be built into a working surface 20

to 40 mm thick and 600 mm deep.

To fit the hob into the unit make a hole of the

dimensions given in the figure below and respect

the indications given in the previous section

“Technical information for the installer”.

INSTALLATION INSTRUCTIONS

82569_GB.fm Page 85 Wednesday, March 21, 2001 5:18 PM

Black process 45,0° 133,0 LPI

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Keine Kommentare

Whirlpool HOB 461 S Bedienungsanleitung Seite 22