Whirlpool ADN 103 Bedienungsanleitung PDF herunterladen (Seite 24)

Procedure:

1) Remove top screw on gearbox.

2) Remove the four screws that hold flange.

3) Remover gearbox using extractor

Assembly:

1) Lubricate motor axle with grease.

2) Place gearbox face up.

3) Screw in (*) screw, place washer and lower gearbox by tightening nut.

WARNING: Do not hammer.

1) Face up clamps socket.

2) Remove (*) screw.

Place washer and tighten until spindle is flush with gearbox axle.

Upper flange

Materials needed:

§ Extractor

§ PHILLIPS N°2 Screwdriver

§ M8 Screws (110 mm)

§ No.12-13 monkey wrench (2)

§ No.8-9 monkey wrench

§ 4, 5 and 6 mm Allen key

§ M8 nuts (2)

Procedure:

1) Disassemble gearbox (see previous section)

2) Remove all four screws holding brackets.

3) Remove all three screws that keep plate and evaporator together.

4) Remove gearbox by hand or using extractor.

Assembly:

1) Clean lodging and neck plate.

2) Mount plate.

IMPORTANT: End of ice discharge flap must be to the right of evaporator's window.

IMPORTANT: Carefully lubricate seal lips (depending on model), avoid damaging them.

1) Replace the three evaporator/plate screws.

2) Replace brackets.

3) Reassemble gearbox. (see previous section)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 32 33

Keine Kommentare

Whirlpool ADN 103 Bedienungsanleitung Seite 24