Whirlpool ADN 103 Bedienungsanleitung PDF herunterladen (Seite 23)

INSPECTION AND REPLACEMENT PROCEDURES

Lower bearing

Materials needed:

- PHILLIPS N°2 Screwdriver

- M8 Screws (*)

- 5 mm Allen key

- Nylon head hammer

- No. 12-13 wrench

Procedure:

1) Disconnect unit.

2) Close faucet.

3) Remove square black plastic lower lid on machine base.

4) Remove drain plug on lower bearing.

5) Remove side screw that holds bearing with a 5 mm Allen key.

6) Introduce M8 50 mm screw in drain plug hole. Bearing will come out as you

tighten screw.

7) Check for wear inside bearing and replace if more than 0.25 mm.

8) Replace o-rings, add silicone and grease, clean evaporator and reassemble.

IMPORTANT!

Side hole must be aligned with the one in evaporator, otherwise you will not be able to

insert Allen screw in place.

1) Open water faucet and check for leaks.

2) Assemble unit and connect to power source.

3) IMPORTANT: DISCARD ICE PRODUCED DURING FIRST 15 MINUTES.

Speed Reducer (Gearbox)

Materials needed:

§ Extractor

§ M8 Screws

§ No.12-13 monkey wrench (2)

§ No.8-9 monkey wrench

§ 6 mm Allen key

§ M8 nuts (2)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 32 33

Keine Kommentare

Whirlpool ADN 103 Bedienungsanleitung Seite 23