Whirlpool AKT 301/IX Bedienungsanleitung PDF herunterladen (Seite 5)

Scrapping the product

• This appliance is marked in conformity with European Directive 2012/19/UE, Waste Electrical and Electronic Equipment (WEEE).

• By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could

otherwise be caused by inappropriate waste handling of this product.

• The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an

appropriate collection centre for the recycling of electrical and electronic equipment.

PRODUCT DESCRIPTION

1. Removable panstand grids

2. Semi-rapid burner

3. Rapid burner

4. Semi-rapid burner control knob

5. Rapid burner control knob

Symbols

Shaded circle Tap closed

Large ame Maximum opening/delivery and electric ignition

Small ame Minimum opening or reduced delivery

PRATICAL ADVICE FOR USING THE BURNERS

This hob has burners of different diameters. For better burner performance, please stick to the following rules:

• use pots and pans with bottoms the same width as that of the burners or slightly larger (see table on the right);

• only use at-bottomed pots and pans;

• use the correct amount of water for cooking foods and keep the pot covered;

• make sure pots on the grates do not protrude beyond the edge of the hob;

• in the case of pans with convex bottoms (WOK), use the support grille, which should be positioned only on the

multi-ring burner.

IMPORTANT: improper use of the grids can result in damage to the hob: do not position the grids upside down

or slide them across the hob.

Do not use:

• cast iron griddles, ollar stones, terracotta pots and pans;

• heat diffusers such as metal mesh, or any other types;

• two burners simultaneously for one receptacle (e.g. sh kettle).

HOW TO USE THE HOB

WARNING

Do not let the burner ame extend beyond the edge of the pan.

IMPORTANT: when the hob is in use, the entire hob area may become hot.

• To ignite one of the burners, turn the relative knob anti-clockwise to the maximum ame setting.

• Press the knob against the control panel to ignite the burner.

• After the burner has ignited, keep the knob pressed for about 5-10 seconds to allow proper device operation.

This burner safety device shuts off the gas supply to the burner if the ame goes out accidentally (because of sudden draught, an interruption in the gas

delivery, boiling over of liquids, etc.).

• The knob must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not remain lit, wait at least one minute before

trying to light it again.