Whirlpool Compactors Bedienungsanleitung PDF herunterladen (Seite 86)

Motor Assembly

Purpose

1. The motor assembly consists of the:

a. Centrifugal switch—which completes a circuit to start the motor windings.

b. Motor—which provides the power to move the ram in the appropriate direction.

c. Drive gear—which interlocks with the driven gear.

Removal—Motor and Centrifugal Switch

1. Disconnect power.

2. Lay compactor on its front; be careful not to damage the loose switch wires.

3. Remove bottom panel.

4. Loosen motor bracket screws.

5. Slide motor forward.

6. Remove driven gear and sprocket assembly.

7. Remove motor bracket from base.

8. Disconnect harness wires from centrifugal switch.

9. Remove wires from centrifugal switch.

10. Remove centrifugal switch from motor by removing the two mounting screws.

NOTE: USE CAUTION WHEN REMOVING THE SWITCH, BECAUSE THE SWITCH IS IN TWO

PIECES.

Testing the Motor

1. Set the ohmmeter at the Rx1 setting.

2. Zero the ohmmeter.

3. Check the motor for ground.

a. All terminals grounded to the metal frame should show an open circuit.

1) If they do not show an open circuit, the motor sould be replaced.

4. Check terminals GY to BR

a. Should read 1 to 4 ohms.

5. Check terminals R to BR

a. Should read 1 to 4 ohms.

6. Check between terminals W to Y

a. Should read 1 to 3 ohms.

7. Check between terminals Y to BU

a. Should read 1 to 3 ohms.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 101 102

Keine Kommentare

Whirlpool Compactors Bedienungsanleitung Seite 86