Whirlpool 30inch(76.2 CM) FREESTANDING GAS RANGES Bedienungsanleitung

INSTALLATION INSTRUCTIONS30" (76.2 CM) FREESTANDING GAS RANGESwith standard clean ovenTable of ContentsRANGE SAFETY ...

10Verify Anti-Tip Bracket Is Installed and Engaged1. Place the outside of your foot against the bottom front of the broiler, and grasp the lower right

114. Check each cooktop burner for proper flame. The small inner cone should have a very distinct blue flame ¼" (0.64 cm) to ½" (0.13 cm) lo

12Complete Installation1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.2

133. Open broiler door and remove broiler pan. The gas pressure regulator is located in the back right hand corner of the broiler compartment.IMPORTAN

14For models with 4 standard burners:For models with 3 standard burners and 1 super burner:5. Place the Natural gas orifice spuds in the parts bag for

15Natural Gas ConversionTo Convert Gas Pressure Regulator1. Turn manual shutoff valve to the “closed” position.2. Unplug range or disconnect power.3.

4. Install the Natural gas orifice spuds using a 7 mm combination wrench. NOTE: Depending on model, the range cooktop may be equipped with 4 standard

2RANGE SAFETYYou can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don'tfollow All

3INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w

4Location RequirementsIMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air. It is the insta

5Cabinet DimensionsCabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and36" (91

6Gas Supply RequirementsObserve all governing codes and ordinances. IMPORTANT: This installation must conform with all local codes and ordinances. In

7Burner Input RequirementsInput ratings shown on the model/serial rating plate are for elevations up to 2,000 ft (609.6 m). For elevations above 2,000

83. Determine and mark centerline of the cutout space. The mounting can be installed on either the left side or right side of the cutout. Position mou

9Typical flexible connection1. Apply pipe-joint compound made for use with LP gas to the smaller thread ends of the flexible connector adapters (see B