Whirlpool ACM 795/BA Bedienungsanleitung PDF herunterladen (Seite 9)

EN 67

Connect the yellow/green earth wire to the terminal with the symbol .

This wire must be longer than the other wires.

1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block hinge (B).

2. Strip approx. 70 mm of sheath from the power supply cable.

3. Strip approx. 10mm of sheath from the conductors. Insert the power cable in the cable clamp and connect the wires to the terminal block as indicated in

the connection diagram located near it.

4. Secure the power cable with the cable clamp.

5. Close the cover (C) and screw it on the terminal block with the previously removed screw.

Each time the power is connected, the hob performs an automatic check for a few seconds.

Connect the appliance to the power supply by means of a multipole switch with minimum contact gap of 3mm.

INSTRUCTIONS FOR USE

Control Panel Description

The panel has touch controls: to use them, just press the corresponding symbol (a light touch is sufcient).

To select and activate the cooking zones

Hob ON/OFF

To set the minute counter

To enable the hold function

Slide touchscreen

To lock the control panel

To select one of the automatic functions

To select the Flexi Cook function

To switch the single cooking zone OFF

First use / after a power failure

After connecting the hob to the electrical power supply, the control panel is locked (the indicator light above the key is ON).

To unlock the control panel, press and hold the key for 3 seconds. The indicator light switches off and the hob can be used normally.

Switching the hob On/Off

To switch the hob on, press and hold the key for approx. 2 seconds: the indicator light above the key switches on and dashes appear inside the circles

indicating the cooking zones.

To switch off, press the same button until the hob switches off. All the cooking zones are deactivated.

The hob automatically switches off if no function is selected within 10 seconds of switching on.

Activation and adjusting cooking zones

Indicates that one of the automatic functions is On

Cooking zone timer

Cooking zone selection and selected cooking zone/power level display

Slide touchscreen (power adjustment)

To switch the single cooking zone OFF

After switching on the hob, position the pot on the chosen cooking zone.

Activate the cooking zone by pressing the corresponding circular key: the number 5 is displayed inside the circle, indicating the intermediate power level.

The hob automatically switches off if no function is selected within 10 seconds of switching on. If you are using a pot that is not suitable,

not correctly positioned or not of the correct dimensions for your induction hob, the message “no pot“ will appear in the display (see gure

on the left). If no pot is detected within 60 seconds, the hob switches off.