Whirlpool WRF954CIHZ Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 13)

3. Tighten the 2 screws at the top of the drawer front (1 on the

left-hand side and 1 on the right-hand side) and install the

2 screws on the bottom.

Final Steps

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

1. Plug into a grounded 3 prong outlet.

2. Reset the controls. See the “Using the Controls” section.

3. Return all removable parts and food to the drawers.

Remove and Replace

Freezer Drawer Fronts

Freezer Drawer

Remove Drawer Front

1. Open the freezer drawer to its full extension.

2. Loosen the 2 top screws that fasten the drawer front to the

drawer glides. The 2 screws (1 on the left-hand side and

1 on the right-hand side) are located inside the drawer front.

3. Remove the 2 screws at the bottom, inside the drawer front

that fasten the drawer front to the drawer glides.

4. Lift up on the drawer front to release the screws from the

drawer glide bracket slot.

A. Drawer glide bracket slots

Replace Drawer Front

1. Pull out the freezer drawer glides to their full extension.

2. Holding the drawer front by its sides, align the top screws,

located at the bottom inside the drawer front, with the drawer

glide bracket slots.

NOTE: It helps if 1 person holds the drawer glides steady

while another person aligns the drawer front and inserts the

studs into the slots.

A. Drawer front screw

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 123 124

Keine Kommentare

Whirlpool WRF954CIHZ Gebrauchs- und Pflegehandbuch Seite 13