Whirlpool WED97HEDW Bedienungsanleitung PDF herunterladen (Seite 18)

1. Remove door from dryer

2. Move the door strike

Using a TORX T25

screwdriver, remove the 2 screws

securing the door strike to the door frame of the dryer. Rotate

the strike 180° and attach to the opposite side of dryer door

frame, as shown.

Remove inner door from outer door

Position the door with the inside of the door facing up. Using

a Phillips screwdriver, remove the 10 screws securing the

inner door to the outer door. Lift off the inner door and set

aside.

IMPORTANT: If the protective lm has not yet been removed

from the dryer, peel the lm from the dryer door before

proceeding.

Using a TORX T25

screwdriver, remove the 4 screws securing

the door hinge to the dryer and lift up and out to remove the

door. Place the door on a soft towel or other

non-scratch surface. Reinstall the 4 screws in the holes.

Reverse door swing round-shaped door – single handle

#2 Phillips screwdriver

Min. 8" long TORX T25

® †

screwdriver

Tools needed:

†

® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.

DOOR REVERSAL (OPTIONAL)

The following instructions are for models with a round and

square-shaped doors.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Whirlpool WED97HEDW Bedienungsanleitung Seite 18