Whirlpool WED97HEDW Bedienungsanleitung PDF herunterladen (Seite 12)

Connect neutral ground wire (E) and neutral wire (white or

center wire) (C) of power supply cord or cable under center,

terminal block screw (B). Tighten screw.

Place ends of remaining wires under outer terminal block

screws. Tighten screws.

Connect a separate copper ground wire (G) under the green

external ground conductor screw (A) to an adequate ground.

Finally, reinsert tab of terminal block cover into slot of dryer

rear panel. Secure cover with hold-down screw. Now, go to

“Venting Requirements.”

Optional External Ground for 3-Wire

Connection (Power Supply Cord Shown)

IMPORTANT: You must verify with a qualied electrician that this

grounding method is acceptable before connecting.

2. Connect neutral ground wire and

neutral wire

1. Prepare to connect neutral ground

wire and neutral wire

3. Connect remaining wires

4. Connect external ground wire

Install the correct strain relief for your electrical connection

method, as shown on page 8 or 10.

Remove center terminal block screw (B). Remove neutral ground

wire (E) from green external ground conductor screw (A).

VENTING

Venting Requirements

WARNING: To reduce the risk of re, this dryer MUST BE

EXHAUSTED OUTDOORS.

IMPORTANT: Observe all governing codes and ordinances.

Dryer exhaust must not be connected into any gas vent,

chimney, wall, ceiling, attic, crawlspace, or a concealed space

of a building. Only rigid or exible metal vent shall be used for

exhausting.

(102 mm)

4" (102 mm) heavy metal exhaust vent

■ Only a 4" (102 mm) heavy metal exhaust vent and clamps

may be used.

■ Do not use plastic or metal foil vent.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Keine Kommentare

Whirlpool WED97HEDW Bedienungsanleitung Seite 12