Whirlpool MEC 3080 IAG Bedienungsanleitung PDF herunterladen (Seite 8)

ELECTRICAL CONNECTION

To be done before connection to the electricity supply.

The appliance must be installed by a qualified technician who is

fully aware of current safety and installation regulations and who

will comply with these regulations.

Make sure that the voltage indicated on the rating plate

corresponds to the voltage in your home.

Regulations require that the appliance is earthed; for this reason

all conductors and earth conductor must be of the appropriate

size.

Make sure the earth connection is made correctly. The

manufacturer declines all liability for injury to persons and

animals or damage to property resulting from failure to observe

the above regulations.

For the electrical connection use a H05V2V2-F type cable as

indicated in the table below:

An all-pole disconnect switch with minimum contact gap

equal to or greater than 3 mm must be used to install the

hob.

Attention

: the power supply cable must be long enough to

allow the hob to be removed from the worktop and must be

positioned so as to avoid damage or overheating caused by

contact with the base.

If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified persons in

order to avoid a hazard.

Voltage Conductors (number and size)

230-240 V

3 X 2.5 mm

min.

1 2 3 4 5 6 7 8

Keine Kommentare

Whirlpool MEC 3080 IAG Bedienungsanleitung Seite 8