N C
M Y
INSTALLATION
Technical information for installer
This cooking hob can be embedded in a
worktop 20 to 50 mm thick.
If there is no oven beneath the cooktop (any
oven installed must be manufactured by us
and equipped with a cooling s ystem), insert a
separator panel at a minimum distance of 20
mm from the bottom of the cooktop.
Note: before installation, make sure that the
local gas delivery conditions (nature and
pressure of gas) are compatible with the
settings of the cooking hob, as indicated on
the rating plate.
x
If a vertical piece of furniture is installed,
there must be a gap of at least 100 mm
between it and the edge of the cooking
hob.
x
Before installing the cooking hob, remove the
plastic film that protects it, if present.
The outer surfaces of the furniture or appliances
adjoining the cooking hob must be heat resistant
(heat protection “Y”, according to standards
EN 60335-2-6).
x
Installation must comply with current local
regulations.
x
In the room where the cooking hob is installed,
there must be enough air to allow the gas to
burn correctly (see relevant table).
x
The natural flow of air must take place through
an adequate opening, that must be:
- permanent, made on one of the outside walls
of the room, and communicating with the exterior
in an area away from sources of pollution;
- built so as to ensure that its openings, both on
the inside and on the outside, cannot be
obstructed, intentionally or accidentally;
- protected by a metal grid or mesh that does
not reduce its working section;
- situated near the floor level and positioned so
as not to interfere with the operation of the fume
exhaust devices.
Assembly
x
Apply the supplied gasket to the cooking
hob (unless it has already been fitted), after
having cleaned its surface as shown in the
relevant figure.
To fasten the cooking hob, use brackets
supplied with it.
1. Fit the brackets into the relevant bores and fasten
them by means of their screws.
2. Make an opening in the worktop, respecting the
dimensions indicated in the enclosed product
description sheet.
3. Install the cooking hob in the worktop.
Important: the power supply c able and plug
must be suitable for the power absorption of
the cooking hob, and the cable must be long
enough to permit the upward extraction of the
cooking hob.
15
15 GB 67872/C
(72 Seiten)
(8 Seiten)
(44 Seiten)
(44 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern