Whirlpool AKT 8900 BA Bedienungsanleitung PDF herunterladen (Seite 5)

- Install a separator panel under the hob.

- The lower part of the product must not be accessible after installation.

- Do not t the separator panel if an undertop oven is installed.

IMPORTANT:

- The distance between the underside of the appliance and the separator panel

must respect the dimensions given in the gure;

- If an oven is installed under the hob, make sure the oven is equipped with a

cooling system;

- Do not install the hob above a dishwasher or washing-machine, so that the

electronic circuits do not come into contact with steam or moisture which could

damage them.

PLACING THE HOB

After the electrical connection (see the chapter “Electrical connection”) position each xing clips on the dedicated slots on the lateral sides of the hob as shown

in the picture. Then push the hob inside the cut out and check that the glass is at and parallel to the worktop. The xing clips are designed for every type of

worktop material (wood, marble, etc).

IMPORTANT:

- Use protective gloves during hob installation

REMOVE THE HOB.

- To remove the hob, use a screwdriver (not provided) to prise o the xing clips on the underside of the appliance.

X 4

ELECTRICAL CONNECTION

- Disconnect the appliance from the power supply.

- Installation must be carried out by qualied personnel who know the current safety and installation regulations.

- The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations

provided in this chapter.

- The power cable must be long enough to allow the hob to be removed from the worktop.

- Make sure the voltage specied on the dataplate located on the bottom of the appliance is the same as that of the home.

WARNING

6-7 cm

Min. 20 mm

Min. 5 mm

WARNING