
24
GAS CONNECTION
ELECTRICAL CONNECTION
The gas supply system must comply with local
regulations.
•
The section “national regulations" gives the specific local
regulations for the country of use.
•
If no information concerning your Country is given, please ask
your installer for details.
•
The connection of the hob to the gas pipe network or gas
cylinder must be made by means of a rigid copper or steel
pipe with fittings complying with local regulations, or by
means of a continuous-surface stainless steel hose complying
with local regulations. The maximum length of the hose is 2
linear metres.
•
Before connecting the tube to the elbow (
A
), fit the gasket (
B
)
supplied, in compliance with
EN 549
.
Be careful:
if a stainless steel hose is used, it must be installed
so as not to touch any mobile part of the furniture. It must pass
through an area free of any hindrances and the entire length of
the hose must be accessible for inspection.
•
After connection to the gas supply, check for leaks with soapy
water.
The electrical connections must comply with the local
regulations.
•
The data relevant to the voltage and power absorption are
indicated on the rating plate.
•
The earthing of this appliance is compulsory by law.
•
When installing, provide for an omnipolar cutout switch with
contact opening distance of at least 3 mm.
•
If the power cable needs replacing, use one having the same
characteristics as the original supplied standard (type
H05V2V2-F T90°C or H05RRF). This operation must be
performed by the After-Sales Service.
•
Do not use extension leads.
• The manufacturer declines any liability for possible
damage or injury due to non-compliance with the
above-mentioned rules.
Earth
(Yellow/Green)
L
N
Kommentare zu diesen Handbüchern