Whirlpool ACM927 WH Bedienungsanleitung PDF herunterladen (Seite 89)

INSTALLATION INSTRUCTIONS

Electrical connection

Before connecting the appliance, make sure:

the mains voltage in your home matches that specified on the appliance dataplate;

the electrical system adequate for appliance max. power absorption specified on the dataplate;

the house electrical system is suitably earthed.

• Connect the appliance to the power supply by means of a suitable disconnecting switch with

min. contact opening distance allowing complete disconnection in category III overvoltage

conditions, in compliance with the installation regulations.

Notes:

After installation, the electrical components must only be accessible with the use of a special tool.

The power cable must be H05VV-F type, in compliance with the table given below.

Connect a power cable of suitable section:

Instructions for the installer

Warning

• Disconnect the appliance from the power supply before carrying out any repairs or

operation.

• Installation must be carried out by a qualified technician, in compliance with the current

safety regulations.

• The appliance must be earthed.

The Manufacturer declines any liability for injury or damage to people or property due to non-compliance

with the above-mentioned regulations. The appliance dataplate is located at the bottom right of frame of

the oven cavity and visible with the door open. Adjustment conditions are given on a label on the packing.

Do not use the oven door for handling operations, or for removing the appliance from the packing.

Ty p e o f a p p l i a n c e Single-phase power supply

230V

Gas-gas/mixed hob with

electric oven

Cable H05VV

-F

Section 3 x 1 mm² when total electrical power

≤

2300W

3 x 1.5 mm² when total electrical power

2300W

Gas connection

For information regarding gas connection instructions, see

the section on “standards” relevant to your country

(“References to National Regulations”).

The gas supply system must comply with current local

regulations.

The appliance must be connected to the gas supply or gas

bottle by means of a rigid copper or steel pipe with fittings

conforming to local regulations or by means of a continuous s/

steel hose conforming to local regulations.

The hose must not be longer than 2 m.

The hose must be connected directly to the elbow of the

outlet union (Fig.1).

Important: When using a hose, it must be installed so

that no part of it is contact with hot parts on the back of

the appliance or cooker. Its path must be free of any

hindrances and in a place where it can be inspected along

the entire length (Fig. 2).

When the appliance is connected to the gas supply, use soapy

water to check for gas leaks.

Fig. 2

Fig. 1

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 111 112

Kommentare zu diesen Handbüchern

Keine Kommentare

Whirlpool ACM927 WH Bedienungsanleitung Seite 89

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Whirlpool ACM927 WH