Whirlpool WFC150MLAW0 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 6)

FOR SERVICE

TECHNICIAN

NOT

REMO

DESTRO

POUR

TECHNICIEN

SEULEMENT

AS ENLEVER

TRUIRE

PART

NO.

46197042905

PAGE

Date : 14-Feb-2008

Starting Quick Test Mode

All of the steps below must be done in sequence in order to reach the Diagnostic Test. This executes the automatic test but does not run

the user interface test

1. Close the door

2. Switch the knob and select the CLEAN WASHER cycle. (See picture below)

3. Press “START” button for 4 times within 5 seconds. (See picture below)

4. Following steps are automatically driven, or they can be manually advanced by pressing the Cancel/Drain button 2 times. See table

“

QUICK DIAGNOSTICS TEST” on next page.

NOTES:

 To cancel out of this mode rotate the selector knob. (This exits you out of the program.)

 Press “CANCEL/DRAIN” button 2 times can advance to the next step of the procedure.

 If the starting procedure fails, switch the knob and back to the CLEAN WASH cycle, the repeat the starting procedure.

NOTES:

Please ensure that current machine status is in PROGRAM (SELECTION) mode.

Otherwise, please follow the instructions below to bring it back to PROGRAM

(SELECTION) mode.

1) PAUSE mode: Press and hold CANCEL/DRAIN button for 3 seconds for

reset, then switch knob to enter PROGRAM mode

2) FAILURE mode: Switch knob to enter PROGRAM mode

3) EXECUTION mode: Press and hold CANCEL/DRAIN button for 3 seconds

for reset, then switch knob to enter PROGRAM mode

4) STANDBY mode: Press START button or switch knob to enter PROGRAM

mode

5) DELAY START mode: Switch knob to enter PROGRAM mode

First press “START” button for 4 times

within 5 seconds

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Keine Kommentare

Whirlpool WFC150MLAW0 Anleitung zur Fehlerbehebung Seite 6