Whirlpool WTW7500GW Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 5)

NOTE: The control panel features a sensitive surface that responds to a light touch of your ﬁnger. To ensure your selections are

registered, touch the control panel with your ﬁnger tip, not your ﬁngernail. When selecting a setting or option, simply touch its name

until the desired section is illuminated.

POWER BUTTON

Touch to turn the washer on. Touching once while the washer

is on will cancel the current cycle, touching twice will turn

the washer off.

WHAT TO WASH/HOW TO WASH

First select a cycle from “What to Wash” and then select

“How to Wash” to get the best combination cycle available

for the type of items you are going to wash. See “Cycle

Guide” for cycle details.

START/PAUSE BUTTON

Touch and hold the START/PAUSE button to begin

the selected cycle; touch again to pause a cycle.

LED TIME/STATUS DISPLAY

The Estimated Time Remaining display shows the time

required for the cycle to complete. Factors such as load

size and water pressure may affect the time shown in

the display. Tightly packed loads, unbalanced loads, or

excessive suds may cause the washer to adjust the cycle

time, as well.

If you have set a delay start to the cycle, the Estimated

Time Remaining display will show the delay time adjusted.

When the cycle is complete, the Done indicator will light

until the lid is opened.

ADD GARMENT

When Add Garment is lit, you may pause the washer,

open the lid, and add items. Touch and hold the

START/PAUSE button to start the washer again.

OPTIONS

You may add or remove options for each cycle. Not all

options can be used with all cycles, and some are preset

to work with certain cycles.

EXTRA RINSE

This option can be used to automatically add a second

rinse to most cycles.

DRAIN & SPIN

This option spins the load and drains any water in the tub.

The load is not rinsed.

RINSE & SPIN

Touch the DRAIN & SPIN button, then touch the EXTRA

RINSE button. This option combines a rinse and high spin

speed for loads requiring an additional rinse cycle

or to complete a load after power interruption.

Also use for loads that require rinsing only.

CLEAN WASHER

Use this every 30 washes to keep the inside of your

washer fresh and clean. This cycle uses a higher water

level. Use with affresh

Washer Cleaner tablet or liquid

chlorine bleach to thoroughly clean the inside of your

washer. This cycle should not be interrupted. See

“Washer Care.”

IMPORTANT: Do not place garments or other items in

the washer during the Clean Washer cycle. Use this cycle

with an empty washer tub.

SIGNAL

Use this to turn the signal indicating the end of a wash

cycle to low, high, or off.

NOTE: You may also adjust the tones that sound when

a feature, setting, or option is touched. Touch and hold

SIGNAL for about 3 seconds to turn key activation

sounds to low, high, or off.

DELAY START

Touch DELAY START to delay the start of the wash cycle

up to 12 hours “12H.” Touch DELAY START until a “0H”

appears in the status display to turn off, or touch the

POWER button.

DEEP WATER

Use this option to add the maximum amount of water

to your wash cycle.

NOTE: Expect longer cycle times due to extended ﬁll

times when using the Deep Water option.

PRESOAK

Use this option to add an extra soak period to any cycle

to help loosen tough stains. The washer will ﬁll and pause

to soak, then begin the selected cycle.

CYCLE MODIFIERS

When you select a cycle, its default settings or the previous

cycle selection used will light up.

TEMPERATURE

Temperature Control senses and maintains uniform

water temperatures by regulating incoming hot and

cold water.

Control Panel and Features

5 6

1 2 3 4 5 6 7 8 9 10 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Whirlpool WTW7500GW Gebrauchs- und Pflegehandbuch Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Waschmaschinen Whirlpool WTW7500GW