Whirlpool W10531342A Bedienungsanleitung

INSTALLATION INSTRUCTIONS20" (50.8 CM) FREESTANDING GAS RANGEwith Standard Clean OvenTable of ContentsRANGE SAFETY...

106. Repeat steps 1 and 2 to ensure that the range foot is engaged in the anti-tip bracket.If the rear of the range lifts more than ½" (1.3 cm) o

114. Remove the battery holder and insert a new 9V DC alkaline battery into it.5. Replace the battery holder in the plastic battery box with the batte

12Check Operation of Cooktop Burners1. If control panel and knobs were removed earlier, reinstall knobs.2. Push in and turn each surface unit control

136. When the flame has been properly adjusted, turn the oven off and wait for the burner to cool down.7. Tighten the shutter screw.8. Reinstall flame

14GAS CONVERSIONSGas conversions from Natural gas to LP gas or from LP gas to Natural gas must be done by a qualified installer.LP Gas ConversionTo Co

154. Remove the cap from the gas pressure regulator using a flat-blade screwdriver.NOTE: Do not remove the spring beneath the cap.5. Turn the cap over

16To Convert Oven Burner1. Open the oven door and remove oven racks, oven tray and flame spreader and set aside.2. Lift oven burner. The orifice spud

174. Remove the cap from the gas pressure regulator using a flat-blade screwdriver.NOTE: Do not remove the spring beneath the cap.5. Turn the cap over

18To Convert Oven Burner1. Open the oven door and remove oven racks, oven tray, and flame spreader and set aside.2. Lift oven burner. The orifice spud

19Notes

2RANGE SAFETYYou can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don'tfollow All

W10531342A© 2012 Whirlpool Corporation.All rights reserved.9/12Printed in Mexico

3In the State of Massachusetts, the following installation instructions apply: Installations and repairs must be performed by a qualified or license

4INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w

5Mobile Home - Additional Installation RequirementsThe installation of this range must conform to the Manufactured Home Construction and Safety Standa

6Gas Supply RequirementsObserve all governing codes and ordinances. IMPORTANT: This installation must conform with all local codes and ordinances. In

7Burner Input RequirementsInput ratings shown on the model/serial rating plate are for elevations up to 2,000 ft (609.6 m). For elevations above 2,000

83. Determine and mark centerline of the cutout space. The mounting can be installed on either the left side or right side of the cutout. Position mou

93. Use a combination wrench and pliers to attach the flexible connector to the adapters. Check that connector is not kinked. Complete Connection1. Lo