INSTALLATION INSTRUCTIONSSLIDE-IN ELECTRIC RANGETable of ContentsRANGE SAFETY...
103-wire connection: Power Supply CordUse this method only if local codes permit connecting chassis ground conductor to neutral wire of power supply c
113. Pull the conduit through the strain relief on cord/conduit plate on bottom of range. Allow enough slack to easily attach wiring to the terminal b
122. Attach terminal lugs to line 1 (black), bare (green) ground, and line 2 (red) wires. Loosen (do not remove) the setscrew on the front of the term
13Level Range1. Place rack in oven. 2. Place level on rack and check levelness of range, first side to side; then front to back.3. If range is not lev
14Moving the RangeWhen moving range, slide range onto cardboard or hardboard to avoid damaging the floor covering.If removing the range is necessary f
W10430947A© 2011. Whirlpool Corporation.All rights reserved.10/11Printed in U.S.A.
2RANGE SAFETYYou can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don'tfollow All
3INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w
4Cabinet DimensionsCabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (9
5If connecting to a 4-wire system:This range is manufactured with the ground connected to the cabinet. The ground must be revised so the green ground
65. To remove cardboard bottom, place range on its back, take 4 cardboard corners from the carton. Stack one cardboard corner on top of another. Repea
7Electrical Connection - U.S.A. Only1. Disconnect power.2. Use Phillips screwdriver to remove the terminal block cover screw located on the back of th
8Style 2: Direct wire strain relief Use Phillips screwdriver to remove screws from panel on back of range. Lift range back panel up and off. Use Ph
9Electrical Connection Options4-wire connection: Power Supply CordUse this method for: New branch-circuit installations (1996 NEC) Mobile homes Re
Kommentare zu diesen Handbüchern