Whirlpool WWDE 7512 Gebrauchs- und Pflegeanleitung PDF herunterladen (Seite 15)

15

EN

2. Press button "Dry only" to dry without a wash

cycle.

3. Select the type of drying desired, by pressing

the “Dryness level” button for automatic

drying levels or the “Drying time” button to

set drying time.

- Automatic drying with selectable levels:

In automatic drying mode, the washer dryer

machine dries the laundry until the set

level of dryness is reached. Pressing button

“Dryness level” once automatically selects the

highest drying level available for the selected

programme. Press the button again to reduce

the drying level.

The following levels are available:

Wardrobe : laundry is completely dry and

ready to be put away in the wardrobe without

ironing.

Hanger : laundry is left slightly damp to

minimise creasing. Garments must be hung to

air dry completely.

Iron : garments are left reasonably damp to

make ironing easier.

- Timer drying mode:

To set a specic drying time, press the “Drying

time” button until the led for the desired time is

illuminated. Values from 180 to 40 minutes are

settable

N.B.: always allow a cooling down period after

drying before opening the door.

5. USING THE CORRECT AMOUNT OF

DETERGENT. Pull out the tray and pour

detergent into the relative compartments

as described in “Detergent dispenser”. This is only

necessary when using a wash only or a wash +

dry programme.

6. DELAYING THE START OF A PROGRAMME. To

set a programme to start at a later time, see the

section “Programmes and Options”.

7. STARTING A PROGRAMME.

Press the START/PAUSE button. The

corresponding indicator light is illuminated,

the door locks and the door open symbol

extinguishes. To change a programme while

a cycle is in progress, press START/PAUSE to

pause the washer dryer (the START/ PAUSE

lamp ashes amber slowly); then select the

required cycle and press START/PAUSE again.

To open the door while a cycle is in progress,

press START/PAUSE; the door may be opened

if the symbol lights. Press the START/PAUSE

button again to resume the programme from

where it was paused.

8. CANCELLING A RUNNING PROGRAMME IF

NECESSARY

Press and hold the button until the washer

dryer stops.

If the water level and temperature are low

enough, the door unlocks and may be opened.

The door remains locked if there is water in

the drum. To unlock the door, switch the

washer dryer on and select the SPIN & DRAIN

programme. The water is emptied and the door

unlocks at the end of the programme.

9. SWITCHING THE WASHER DRYER OFF AT THE

END OF A PROGRAMME.

At the end of the programme, the door open

light will switch on. The door can only be

opened when the symbol lights. Check that

the door open light is on, then open the door

and remove the laundry.

Press to switch the washer dryer o. To save

energy, if the washer dryer is not switched

o manually with the button, it turns o

automatically approximately 30 minutes after

the end of the programme.

Leave the door ajar to let the interior of the

washer dryer dry.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 37 38

Kommentare zu diesen Handbüchern

Keine Kommentare