Whirlpool AMB 892/G Bedienungsanleitung PDF herunterladen (Seite 13)

149

Select the best location

Location for Installing the Indoor Unit

•

Where there is no obstacle near the air outlet and air can easily be blown

to every corner.

•

Where piping and wall hole can easily be arranged.

•

Observe the required distance from ceiling and wall according to the

wiring diagram.

•

Where the air filter can easily be removed.

•

Keep the unit and remote control 1 m or more from the television, radio

etc.

•

The remote controller will operate abnormally in a room fitted with digital

lights.

•

Do not put anything near the air inlet that could obstruct it.

•

In a place that can bear the weight and will not increase operating noise

and vibrations.

Location for Installing the Outdoor Unit

•

Install in a convenient and well-ventilated place; avoid installing it where

flammable gas could leak.

•

Observe the required distance from the wall.

The pipe is 15 meters in length maximum. If it exceeds 7 meters,

additional refrigerant of 40 grams per meter is needed. The permitted

elevation between indoor and outdoor units is 5 meters. If the outdoor

unit is higher than the indoor one, an elbow in the pipe before entering

indoor side is necessary.

•

Do not install the outdoor unit in a dirty or greasy place, near a

vulcanization gas exit or highly salty seashore.

•

Avoid installing it at the roadside where it could be soiled with muddy

water.

•

A fixed base where operating noise will not increase.

•

Where the air outlet is not obstructed.

•

Install where the neighbors will not be annoyed by operating noise or

discharged air.

Outdoor unit installation

Install Drain Port and Drain Hose (for heat-pump model

only)

The condensate drains from the outdoor unit when the unit operates in

heating mode. In order not to disturb your neighbours and protect the

environment, install a drain port and a drain hose to direct the

condensate water. Just install the drain port and rubber washer on the

chassis of the outdoor unit, then connect a drain hose to the port as

shown in the figure on the right.

Install and Fix Outdoor Unit

Fix with bolts and nuts tightly on a flat and strong floor. If installed on

the wall or roof, make sure to fix the support well to prevent it from

shaking due to serious vibrations or strong wind.

Outdoor Unit Piping Connection

Remove the valve caps from the 2-way and 3-way valve. Connect the

pipes to the 2-way and 3-way valves separately according to the

required torque.

Outdoor Unit Cable Connection (see page 38)

Model

Max. Allowable

Tubing Length

at Shipment (m)

Limit of

Tubing

Length (m)

Limit of

Elevation

Difference H (m)

Required

amount of

additional

refrigerant (g/m)

7K, 9K, 12K 5 15 5 25

Indoor unit A

elevation should

be less than 5m

To indoor Unit B

Outdoor unit

elevation should

be less than 5m

Indoor unit A

The

maximum

length of

pipes is 15

meters

Outdoor

unit

Indoor

unit B

Drain port

Drain hose

(prepare by user)

Washer

Curled tube for

returning liquid

33933051GB.fm Page 149 Tuesday, January 18, 2005 3:31 PM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Whirlpool AMB 892/G Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Split-System-Klimaanlagen Whirlpool AMB 892/G