Whirlpool AMB 889/G Bedienungsanleitung

28INSTRUCTIONS FOR USESPLIT CEILING-MOUNTED AIR CONDITIONER WITH GREEN GAS PREPARATION BEFORE USESAFETY PRECAUTIONSIDENTIFICATION OF PARTSREMOTE CONTR

37MAINTENANCEBefore using a ladder or other means, inspect it to make sure it is safely placed. Indoor unit maintenance Unplug from the power supplyTu

38PROTECTIONOperating conditionProtection device featuresNoise pollutionInspectionHEATING mode featuresThe protective device may trip and stop the app

39TROUBLESHOOTINGTrouble AnalysisDoes not run• Is the protection device or fuse blown?• Sometimes it stops working to protect the appliance.• Are the

40INSTALLATION INSTRUCTIONSSelect the best locationLocation for Installing the Indoor Unit•Where there is no obstacle near the air outlet and air can

41Indoor unit installation(Note: The instructions below are only applicable to a house made of concrete.) •Measure the distance H between the roof and

42Pipe and cable connections Outdoor unit installation•Install it on a strong and flat surface or bracket.•Keep it at least 150 mm above the ground. •

43Outdoor unit piping connection Pipe preparation Measure the length of pipes according to the location and direction of indoor and outdoor units and

44Air purgingAfter connecting the indoor and outdoor units, evacuate air and moisture from the refrigerant system using a vacuum pump, as shown below.

45After evacuating the air, check for tightness of all the joints of indoor and outdoor units with a halogen detector or liquid soap before wrapping.

46Electrical Wiring DiagramThe electrician should cut proper length cables and cords, in compliance with local electrical and fire safety codes. Elect

29PREPARATION BEFORE USESAFETY PRECAUTIONSBefore using the air conditioner, be sure to check and preset the following.• Remote Control presettingThe r

47Match the colour when connecting the indoor and outdoor units (as shown in the figure above) Note: Make sure to wrap the cords properly with adhesiv

48Match the colour when connecting the indoor and outdoor units (as shown in the figure above) Note: Make sure to wrap the cords properly with adhesiv

49Operation test After checking, switch on the appliance. If a “beep” is heard, the appliance is working normally, otherwise check it again. (Since th

50•Buckle the front panel to the main unit, paying attention to the correct direction of the front panel. Two of the buckles hook inside, while the ot

51Trial run 1.Before the trial run After installation, piping and cable connections of both indoor and outdoor units, check that:•there are no refrige

30IDENTIFICATION OF PARTSIndoor unitA- Front panel B- Air louvers C- Corner panel D- Air filter E- Air intakeF- DisplayG- Air outletH- Remote ControlO

311. Heater indicator (Red) It lights up when the electric heater (optional) is working and goes out when the heater is off. 2. Drain indicator (Orang

32REMOTE CONTROLNOTE: The remote control display continues indicating even when the unit has run down.The remote control transmits signals to the syst

33OPERATION INSTRUCTIONSOperating modes1. Selecting modeEach time MODE button is pressed, the operation mode is changed in sequence:COOLING DRY FAN

345. Airflow direction controlVertical airflow controlPress the SWING button to set the airflow angles.The airflow direction can be adjusted to your o

356th Sense modeElectric heating mode (optional)When you feel the temperature is not warm enough or need heat faster in heating mode, use the electric

36Sleep modeSLEEP mode can be set in COOLING or HEATING operation mode.This function gives you a more comfortable environment for sleep.In SLEEP mode,