Whirlpool SD53ESB Bedienungsanleitung PDF herunterladen (Seite 10)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Grip the door on the two external sides

and close it approximately half way.Pull the

door towards you lifting it out of its seat (see

diagram).

To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged,

please contact your nearest Service Centre (see Assistance). We recommend

that the oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the

lamp-holder.

2. Remove the light bulb and replace

it with a similar one: Wattage 25 W,

cap E 14.

3. Replace the glass cover (see

diagram).

! Do not use the oven lamp as/for ambient lighting.

WHEN USING THE MAIN OVEN

YOU MUST ENSURE THAT THE

BASE OF THE CAVITY IS NOT

COVERED WITH ALUMINUM

FOIL, UTENSIL OR ANY OTHER

FORM OF COVERING. FAILURE

TO DO THIS MAY RESULT IN

THE CAVITY BEING DAMAGED.

! ATTENTION

Automatic cleaning using the Diamond Clean cycle

The Diamond Clean mode is an automatic cleaning cycle which releases

steam inside the cavity and uses the exclusive Diamond Clean enamel to

make it easy to remove any dirt residues from the cavity and accessories.

The Diamond Clean cycle can be used to keep the oven always clean.

During the cleaning process steam is released inside the cavity which, together

with the titanium-based Diamond Clean enamel (on the inside walls of the

oven and dripping pans), makes it easy to clean the oven.

In order to start the Diamond Clean function:

1. Wait for the oven to cool down.

2. Place the dripping pan on level 1 and pour in 150g of water. A smaller or

larger quantity of water than recommended may affect the cycle results. Do

not use detergents.

3. Close the oven door.

4. Turn the PROGRAMMES knob to the TRADITIONAL programme position.

5. Turn the THERMOSTAT knob to the 100°C position.

6. After 10 min. turn the PROGRAMMES knob to the “0” position.

! To prevent any steam leaks do not open the door during the cycle.

Once the automatic cleaning cycle is over

Wait for the oven to cool down and remove any water residues using a

non-abrasive sponge. Waiting more than 10 minutes before carrying out this

operation may affect the results.

To remove stubborn dirt we recommend repeating the cycle by adding a few

detergent drops to the water.

1 2 ... 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Whirlpool SD53ESB Bedienungsanleitung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Öfen Whirlpool SD53ESB