Whirlpool Automatic Ice Maker Installationsanleitung PDF herunterladen (Seite 14)

14

Mounting the ice maker

Refer to the side diagram for the following

step.

1. Look at the ice maker’s fill cup and note

that the rear of the cup has a “U” shaped

groove (either of the sides may also be

grooved). Use your fingers, (or a pair of

pliers, if it is easier), and remove only the

rear “knock-out” from the cup. Bend the

area back and forth inside the groove until it

breaks free. The fill tube will fit through this

cutout when you install the ice maker.

Refer to the side diagram for the following

steps.

1. Remove and discard the blank connector

from the wiring harness. To remove it, lift

the locking arm on the side of the blank

connector so it is over the tab of the wiring

harness connector, and pull the blank

connector off.

2. Insert the end of a small-bladed screwdriver

under the edges of each of the three ice

maker mounting hole plugs in the side of

the freezer liner, and pry them out of their

holes. You can discard the plugs.

3.

For Top/Bottom Freezers Only:

Partially

install two

3

⁄4

"

hex-head sheet-metal screws

into the two top mounting holes (shown in

the diagram) of the freezer liner. You will

hang the ice maker over these two screws

later, so make sure that they protrude out

far enough.

4.

For Side-By-Side Models Only:

Refer to

DETAIL A and mount the two mounting

clips (from the ice maker kit) to the top

mounting holes of the freezer liner with two

3

⁄4

"

hex-head sheet-metal screws. Make

sure that both clips hang straight down and

then tighten the screws.

Installing the ice maker clips

DETAIL A

SXS MODELS

ONLY

Ice maker

clips

Removing the knock-out

Remove knock-out

Fill cup at rear

of ice maker

Wiring

harness

connector

Blank connector

(remove and

discard)

Lift locking

arm over tab

Tab

Hole

plugs

3

⁄4" hex-head

sheet-metal

screws

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare