
12
Installation and fixing
WARNING
The installer is responsible for any damage
or injury resulting from incorrect
installation.
To guarantee correct operation, the appliance must be
installed on a perfectly flat surface.
The worktop must be -20 50 mm thick.
If necessary, cut the kitchen unit and worktop to fit before
installing the hob. Clean the cutout of any chips that could
compromise appliance operation.
For cut-out dimensions, see the figure below.
For
flush mounted installation or setting into a
marble worktop
, contact the After-sales Service for the
installation kit and necessary instructions.
• 4812 310 19277 Installation kit for marble
worktop.
• 4801 211 00112 Installation kit for flush fitted
worktop.
To guarantee correct operation, the appliance must be
installed on a perfectly flat surface.
The worktop must be 20-50 mm thick.
If necessary, cut the kitchen unit and worktop to fit before
installing the hob. Clean the cutout of any remaining dust
that could compromise appliance operation.
If a column unit is installed adjacent to the hob, leave a
distance of at least 100 mm from the edge of the hob.
Assembly
1.
Position the clips (
A
) in the spaces provided on the
hob trim (Fig. 3) if not already positioned.
2.
Measure the centre point of the vertical sides of the
cut-out (Fig. 1)
3.
Fit the brackets (
C
) in the centre of the vertical sides,
aligning the upper edge of the brackets so that they are
flush with the worktop surface (Fig. 2).
4.
Fix the brackets with the 4 screws supplied (
B
) using
the holes provided.
5.
Insert the hob in the cutout, making sure the clips (
A
)
are secured in the spaces provided (Fig. 4).
490
+2
0
580
510
483
553
min. 50
770
483
510
742
R min. 6.5
max. 8
min. 50
52
+1
0
560
+2
0
490
+2
0
52
+1
0
R min. 6.5
max. 8
750
+2
0
Dimensions in mm
C
B
Fig. 2
Fig. 1
41901112GB.fm Page 12 Thursday, August 21, 2008 12:25 PM
Kommentare zu diesen Handbüchern