Whirlpool CHI 6640F IN Bedienungsanleitung PDF herunterladen (Seite 10)

EN16

Residual heat indicator.

The hob is fitted with a residual heat indicator for each cooking zone. These indicators alert the user when cooking zones are still hot.

If the display shows , the cooking zone is still hot. If the residual heat indicator of a given cooking zone is lit, that zone can be used, for example, to keep a

dish warm or to melt butter.

When the cooking zone cools down, the display goes off.

Incorrect or missing pot indicator.

If you are using a pot that is not suitable, not correctly positioned or not of the correct dimensions for your induction hob, the message “no pot” will

appear in the display (see figure at side). If no pot is detected within 60 seconds, the hob switches off.

Fast boil function (Booster)

This function, only present on some cooking zones, makes it possible to exploit the hob’s maximum power (for example to bring water to the boil very quickly). To

activate the function, press the required booster button “P” appears on the display. After 10 minutes’ use of the booster function, the appliance automatically sets the

zone to level selected on oven knob.

Flexi cook

Where present, this function allows the cooking zone to be used as two separate zones or as a single extra large zone. It is perfect for oval, rectangular and elongated

pans (with maximum base dimensions of 39x23 cm) or more than one standard pan in the same time. In order to activate the flexicook function, rotate the knob on

the oven (7) on flexi function . The right display show F. Rotate the knobs on the oven (6) from 0 1 2…9. The two displays show the power level selected

with knob (6). To change the power level (from 1 to max. 9) rotate the knob on the oven (6). To deactivate the Flexi cook function, rotate the knob on the oven (7)on 1

2 …9 function.

The message “no pot” will appear on the display of the zone that is not able to detect any pot (because of missing pot, or misplaced or not suitable for

induction hob). This message remains active for 60 seconds: in this time you can add or slide pots within the flexicook area as you prefer.

After 60 seconds if no pan is placed on the zone, the system stops “searching” pots on that zone, the symbol remains visible on the display to remind that the zone

is disabled.

To reactivate the Flexicook function, rotate the knob on the oven (7) on flexi function .

The Flexi cook function is also able to detect when a pot is moved from one zone to the other one within the flexi cook area keeping the same power level of the zone

where the pan originally was placed (see the example in the figure below: if the pot is moved from the front heater to the rear heater, the power level will be shown

on the display corresponding to the zone where the pot is placed).

Important: make sure to place the pans centered on the cooking zone placed in the center of the single cooking zone.

In case of big pot, oval, rectangular and elongated pans make sure to place the pans centered on the cooking zone.

Examples of good pot placement and bad pot placement :