Whirlpool PCTOC140060NE Bedienungsanleitung PDF herunterladen (Seite 3)

INSTALLATION

• The cooktop must be set into a worktop between 20 mm and 50 mm deep.

• There must be nothing between the cooktop and the oven (cross rails, brackets, etc.).

• If the cooktop is to be installed next to a column unit, leave a distance of at least 100 mm from the edge

of the cooktop to the side of the column unit.

• For built-in dimensions and installation see the picture in this paragraph.

• Apply the supplied gasket to the cooktop (unless it has already been tted), after having cleaned its surface.

• We recommend you seal the internal edges of the worktop with wood glue or silicone.

• Do not install the cooktop near a dishwasher or washing machine, so that the electronic circuits do not

come into contact with steam or moisture, which could damage them.

• ATTENTION: to install the hob on other surfaces than wood (marble, plastic, ceramic, marble, stone,

etc.) remember to ask After Sales Service for the xing plates (g. 2) .

PLACING THE HOB

Important: remove any protective lm before installing the hob.

Make sure that the opening in the worktop for the hob is cut according to the dimensions given in the drawing,

paying attention to the tolerance range. The hob should not be forced into the worktop. Forcing the glass-

ceramic top may cause it to crack (even at a later date)!

• If the worktop is made of wood, use the appropriate brackets, spring clips and screws provided.

• Position the 4 clips (A), if not alreay tted, around the cooktop frame, in the slots provided, see Fig. 1.

• Measure the centre of the vertical sides of the cut out a shown in Fig. 2.

• Position the centre of the brackets (C) on the centre of the side previously identied.

• The upper edge of the brackets must be ush with the worktop surface.

• Secure using the 4 screws (B)provided that should screwed into the pre-prepared holes.

• Insert the cook hob into the pre-prepared hole ensuring that the clips (A) lodge into the bracket slots provided

(C Fig. 4 e 5).

• If the worktop is made of marble, plastic, ceramic, stone, etc., the hob must be secured with special

brackets (C) (g. 2). Fit the hob into the worktop (g. 1). Place the 4 brackets (C) in position shown in g. 6.

Fasten the 4 screws (E) in the positions (D) (g. 6).

DIMENSIONS AND DISTANCES TO BE MAINTAINED

R = Min. 6,5 mm

Max. 16 mm

490 mm

560 mm

Min. 50 mm

min 20 mm

482 mm

552 mm

40 mm

510 mm

580 mm

580 X 510 mm

1 2 3 4 5 6

Keine Kommentare

Whirlpool PCTOC140060NE Bedienungsanleitung Seite 3