Whirlpool LDR3822PQ Bedienungsanleitung PDF herunterladen (Seite 8)

Install Cord Bracket and Casters

Do not move dryer into its final position until the following steps

have been performed.

Install cord bracket

1. Remove tape from the power cord and the rear panel.

2. Insert cord brackets into slotted holes in rear panel and

secure with screws provided.

NOTE: Power supply cord may be wrapped around the bracket s

for storage convenience when dryer is not in use.

Install casters

1. Lay the dryer on its side.

2. Use the carton to prevent damage to the dryer.

3. Screwcas ters into dryer base at four corners and tighten

securely.

4. Set the dryer upright. In doing so, be careful that the dryer

does not roll away from you.

NOTE: Permanent installations require 4 dryer feet. See

“Assistance or Service” section for ordering information.

Connect Vent

1. Using a 4" (102 mm) clamp, connect vent to exhaust outlet

in dryer. If connecting to existing vent, make sure the vent is

clean. The dryer vent must fit over the dryer exhaust outlet

and inside the exhaust hood. Make sure the vent is secured

to exhaust hood with a 4" (102 mm) clamp.

2. Move dryer into final position. Do not crush or kin k vent.

Make sure dryer is level.

3. (On gas models) Checkt o be sure there are no kinksin

the

flexible gas line.

Complete Installation

1. Check to be sure all parts are now installed. If there is an

extra part, go back through the steps to see wh ich step was

skipped.

2. Check to be sure you have all of your tools.

3. Dispose of/r ecycle all packaging materials.

4. Check the dryer’s final location. Be sure the vent is not

crushed or kinked.

5. Check to be sure the dryer is on a level surface.

6. Plug into a grounded 3 prong outlet. Turn power on.

7. Remove the blue protective film on the console and any tape

remaining on the dryer. Remove tape from the lint screen

(located on inside back wa ll of dryer).

8. Read “Dryer Use.”

9. Wipe the dryer drum interior thoroughly wi th a damp cloth to

remove any dust.

10. To test the dryer, set the dryer on a full heat cycle (not an air

cycle) for 20 minutes and start the dryer.

If the dryer will not start, check the following:

Controls are set in a running or “On” position.

Start button has been firmly pushed.

Dryer is plugged into a grounded 3 prong outlet.

Electrical supply is connected.

House fuse is intact and tight, or circuit breaker has not

tripped.

Dryer door is closed.

11. When the dryer has been running for 5 minutes, open the

dryer door and feel for heat.

If you do not feel heat, check the following:

Controls are set on a heated cycle, not an air cycle.

NOTE: You may notice an odor when dryer is first heated.

This odor is common when the heating element is first used.

The odor willgoaway.

A. Cord bracket

B. Slotted hole

C. Screw

WARNING

Excessive Weight Hazard

Use two or more people to move and install dryer.

Failure to do so can result in back or other injury.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Whirlpool LDR3822PQ Bedienungsanleitung Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Waschmaschinen Whirlpool LDR3822PQ