Whirlpool HSCX 90430 Gebrauchs- und Pflegeanleitung

Health & Safety, Use & Care and Installation guidewww.whirlpool.eu/register

10PRODUCT DESCRIPTIONAPPLIANCECONTROL PANEL1. Worktop2. Control panel3. Water tank4. Door5. Door handle6. Door lter (behind door) 7. Plinth8. Adjus

11ENDOORDRUM LIGHT (if available)AVAILABLE ACCESSORIES To open the door, pull the handle.If you interrupt a running programme by opening the door, th

12FIRST TIME USEHOW TO USE THE APPLIANCE1. WHEN SWITCHING ON THE DRYER FOR THE FIRST TIME, YOU WILL BE ASKED TOSet the desired languageTurn the knob

13ENDAILY USE WARNINGMake sure that no lighters or matches remain in the laundry. Make sure that the laundry is not soaked with ammable liquids.1. L

14mum 180 minutes (three hours).Make sure that the Drying time button lights up. Turn the knob to select the desired drying / airing time. Conrm it b

15ENThe dryer switches o automatically in about a quarter of an hour after programme end, to save energy. If not switched o right after programme en

16PROGRAMME Type of Wash and RecommendationsCare LabelsRegulationsSYNTHETICS For drying laundry made of synthetic bres.max. load (kg): 3.5default

17ENPROGRAMME Type of Wash and RecommendationsCare LabelsRegulationsSTEAM REFRESH For refreshing laundry with steam. Specically designed to refresh

18max = maximum capacity of the dryer Programme durations indicated in the table are default values. The programme duration mainly depends on the hum

19ENThis accessory is designed to be used:With Water: in programme Steam Refresh, to provide the necessary humidityREFRESHING BALLUSE WITH PROGRAMME S

2ENGLISH ...3

20STEAM OPTIONFRESH CAREGENTLEDRYING TIME OPTIONDRYNESS LEVELMinimizes creasing of garments made of cotton, synthetics and their blends by adding a hu

21ENFUNCTIONSON/OFFKNOBSTART/PAUSEKEY LOCKFINISH INTo switch the dryer on: press the button until the Start/Pause button lights up. To switch the drye

22The colon on the display between hours and minutes blinks. The programme starts automatically, in time to be nished at the end of the delay period.

23ENINDICATORSENERGY MONITORFAILUREThe less levels of the energy monitor are lit, the more economic is your programme setting.For any failure indicati

24ENERGY SAVING TIPS• To reduce the drying time, make sure that the laundry is spun with the maximum possible spin speed of the wash programme. This

25ENCLEANING & MAINTENANCEEMPTYING THE WATER TANKEmpty the water tank after each programme, provided the drain hose is not connected to your sewa

26Clean the door lter after each programme.Make sure that the laundry is unloaded. Open the door.1. Remove the door lter by pulling it upwards. 2. P

27EN4. Clean the lter foam and the lter by hand or under running water. Do not wash the lter foam in the washing machine.5. Carefully wring out the

288. Insert the bottom lter again. Make sure that it is completely integrated in the lter compartment.9. Clap the lter handle downwards.10. Close t

29ENCLEANING THE OUTSIDE OF THE DRYERUse a soft damp cloth to clean the outer parts of the dryer.Do not use glass or general purpose cleaners, scouri

3ENENGLISHHEALTH & SAFETY, USE & CARE and INSTALLATION GUIDESIndexHealth and Safety guideSAFETY INSTRUCTIONS ...

30REVERSING THE DOOR STOPIf needed, the door stop of the dryer door can be reversed. Use pliers and a cross-head screwdriver for the procedure. For re

31EN5. Unscrew the bottom screw, to release the cover frame on the front of the door.6. Turn the door and lay it down on the door glass. 127. Carefull

329. Remove the two side screws. Do this on both sides of the door.10. Remove the 4 inner screws on each side of the door.11. Remove the side parts on

33EN13. Fix the 2 side screws on both sides of the door again.14. Fix the 4 inner screws on each side again.15. Turn the door and lay it down on the d

3417. Turn the door again and lay it upside down. Fix the bottom screw again.18. Insert the door lock on the right side of the door opening. Press it

35ENYour dryer is equipped with various automatic safety functions. These enable failures to be detected in good time and the safety system can react

36WATER DROPLETS ARE BENEATH THE DRYERBottom lter not inserted correctly• Check position of the bottom lter and make sure it is completely integrat

37ENFAILURE INDICATOR AND MESSAGESMake sure to • Empty the water tank after each programme• Clean the door lter after each programme• Clean the bo

38Below is a summary of possible failure causes and solutions. If the problem persists after having followed the instructions as indicated below, pres

39ENTRANSPORT AND HANDLING1. Unplug the dryer.2. Make sure that door and water tank are properly closed.3. If the drain hose is connected to your sewa

4INDICATORS ...23ENERGY SAVING ...

40AFTER-SALES SERVICEBEFORE CALLING THE AFTER-SALES SERVICEIF AFTER THE ABOVE CHECKS THE FAILURE STILL OCCURS, GET IN TOUCH WITH THE NEAREST AFTER-S

41EN2a. 2b.1.

423a.3b.max 2 cmmax 0.79 inch

43EN4.max 100 cm39 inch12

445.6a.6b... xxx V ~ xx Hz xx A IPX4 EV Dxxxx xxxx xxxx

45EN

Whirlpool is a registered trademark of Whirlpool, USAEN400010838911001n

5ENSAFETY INSTRUCTIONSIMPORTANT TO BE READ AND OBSERVEDBefore using the dryer carefully read, Health and Safety and Use and Care guides.Keep these in

6cycle unless all items are quick-ly removed and spread out so that the heat is dissipated.The last phase of the drying cy-cle is done without heat (c

7ENfuse cover. 3. Ret both into plug.Important:The fuse cover must be retted when changing a fuse and if the fuse cover is lost the plug must not be

8SCRAPPING OF HOUSEHOLD APPLIANCESWhen scrapping the dryer, make it unusable by cutting o the power cable and removing the doors and shelves (if pre-

9ENDECLARATION OF CONFORMITYThis dryer has been designed, constructed and distributed in compliance with the safety requirements of European Directiv