Whirlpool HSCX 10441 Betriebsanweisung Seite 7

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 8
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 6
7
EN
controlled via 6th Sense Live app.
If you start a programme remotely, at the end of the programme
the dryer will automatically exit the Remote Control mode and will
switch o.
To manually exit Remote Control:
With the machine in Remote Control, press again the Remote
Control button. You will regain local control over the control panel
of the dryer.
Key lock
To lock keys of the control panel against unwanted operation.
To lock the keys:
The dryer must be switched on.
Press and hold the Options button until the display
indicates that the keys are locked. Buttons and keys are
locked now. Only the On/O button works
If you switch the dryer o and on again, the key lock
remains active until you unlock it.
To unlock the keys:
Press and hold the Options button until the display indicates that
the keys are unlocked.
INDICATORS
Connection status
If your dryer has been already connected to the Internet (see 6th
Sense Live Remote Control / Setup Procedure section in the Use and
Care Guide) this indicator provides a feedback about the status of
the Internet connection through your WiFi router.
When you switch on the dryer, the connection status indicator
blinks: the dryer is looking for a connection.
When it becomes solidly lit, it means that the dryer is properly
connected to the Internet.
The strength of the wireless signal is shown by the indicator (when
all the elements of the indicator are lit, the signal strength is strong).
Failure
For any failures, refer to section TROUBLESHOOTING in the USE AND
CARE GUIDE.
Energy monitor
Gives feedback about the energy consumption of the programme
setting.
The less indicators light up, the more economic is your programme
setting.
CARE AND MAINTENANCE
Switch off and unplug the dryer before doing any cleaning and maintenance.
Caution, the water in the water tank can still be hot.
Empty water tank after each drying cycle
Hold the handle and carefully pull out the water tank. Hold the
full water tank with both hands. Empty the water and insert the
container by pushing it back into place. Make sure that it is properly
inserted.
Clean door lter after each drying cycle
Open the door and remove the door lter by pulling it upwards.
Press the button to open the door lter. Remove the lint inside.
Close the lter and reinsert it in the right direction, so that it
completely integrates in the lter chamber.
Clean the bottom lter after about every fth drying cycle
Open the bottom ap. Hold the handle and pull out the bottom
lter.
Remove the foam from the bottom lter, to clean it. Clean the lter
foam and the lter by hand or under running water. Do not wash the
lter foam in the washing machine. Wring out the lter foam. Do not
insert it in the bottom lter dripping wet.
Fix the lter foam on the bottom lter. Clean the lter chamber of
the dryer with a damp cloth or carefully with a vacuum cleaner.
Insert the bottom lter again. Clap the lter handle down and close
the bottom ap.
Seitenansicht 6
1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare