Whirlpool DSCX 10123 Gebrauchs- und Pflegeanleitung

Health & Safety, Use & Care and Installation guidewww.whirlpool.eu/register

10PRODUCT DESCRIPTIONAPPLIANCECONTROL PANEL1. Worktop2. Control panel3. Water tank4. Door5. Door handle6. Door lter (behind door) 7. Bottom lter (

11ENDOORDRUM LIGHT (if available)AVAILABLE ACCESSORIES To open the door, pull the handle.If you interrupt a running programme by opening the door, th

12FIRST TIME USEHOW TO USE THE APPLIANCE1. CHECK WATER TANKMake sure that the water tank is correctly inserted2 . CHECK DRAIN HOSEMake sure that the

13ENDAILY USE WARNINGMake sure that no lighters or matches are left in clothing. Make sure that the laundry is not soaked with ammable liquids.1. LO

14Set dryness level, if needed If you want to change the dryness level, make sure that the Dryness level button « lights up. Turn the knob to sele

15ENIf not switched o right after programme end, the dryer will tumble the laundry for about 10 minutes, to prevent creasing. The display shows an an

16PROGRAMME Type of Wash and RecommendationsCare LabelsRegulationsSYNTHETICSFor drying laundry made of synthetic bres.max. load (kg): 3.5default p

17ENPROGRAMME Type of Wash and RecommendationsCare LabelsRegulationsDRYING TIMETime-restricted drying programme. Select programme duration by option

18STEAM OPTIONFRESH CAREGENTLEDRYING TIME OPTIONDRYNESS LEVELMinimises creasing of garments made of cotton, synthetics and their blends by adding a hu

19ENFUNCTIONSON/OFFKNOBSTART/PAUSEKEY LOCKSTART DELAYTo switch the dryer on: press the button until the Start/Pause button lights up. To switch the dr

2ENGLISH ...3

20The programme starts automatically at the end of the delay period. On programme start, the delay on the display is replaced by the remaining program

21ENINDICATORSWATER TANK FULL => empty water tankBOTTOM FILTER CLOGGED=> clean bottom lterDOOR FILTER CLOGGED=> clean door lterFAILUREF..Fo

22ENERGY SAVING TIPS• To reduce the drying time, make sure that the laundry is spun with the maximum possible spin speed of the wash programme. This

23ENCLEANING & MAINTENANCEEMPTYING THE WATER TANKEmpty the water tank after each programme, provided the drain hose is not connected to your sewa

24Clean the door lter after each programme.Make sure that the laundry is unloaded. Open the door.1. Remove the door lter by pulling it upwards. 2. P

25EN4. Clean the bottom lter under running water; wipe away dust and lint.5. Wipe the bottom lter dry, so that it is not dripping wet anymore.6. Cle

267. Push the bottom lter back into the lter compartment; make sure that it is completely integrated. Turn both locking bars (right and left) back i

27ENCLEANING THE OUTSIDE OF THE DRYERUse a soft damp cloth to clean the outer parts of the dryer.Do not use glass or general purpose cleaners, scouri

28REVERSING THE DOOR STOPIf needed, the door stop of the dryer door can be reversed. Use pliers and a cross-head screwdriver for the procedure. For re

29EN5. Unscrew the bottom screw, to release the cover frame on the front of the door.6. Turn the door and lay it down on the door glass. 127. Carefull

3ENENGLISHHEALTH & SAFETY, USE & CARE and INSTALLATION GUIDESUse and Care guideIndexHealth and Safety guideSAFETY INSTRUCTIONS ...

309. Remove the two side screws. Do this on both sides of the door.10. Remove the 4 inner screws on each side of the door.11. Remove the side parts on

31EN13. Fix the 2 side screws on both sides of the door again.14. Fix the 4 inner screws on each side again.15. Turn the door and lay it down on the d

3217. Turn the door again and lay it upside down. Fix the bottom screw again.18. Insert the door lock on the right side of the door opening. Press it

33ENYour dryer is equipped with various automatic safety functions. These enable failures to be detected in good time and the safety system can react

34WATER DROPLETS ARE BENEATH THE DRYERBottom lter not inserted correctly• Check position of the bottom lter and make sure it is completely integrat

35ENFAILURE INDICATOR AND MESSAGESMake sure to • Empty the water tank after each programme• Clean the door lter after each programme• Clean the bo

36Below is a summary of possible failure causes and solutions. If the problem persists after having followed the instructions as indicated below, pres

37ENTRANSPORT AND HANDLING1. Unplug the dryer.2. Make sure that door and water tank are properly closed.3. If the drain hose is connected to your sewa

38AFTER-SALES SERVICEBEFORE CALLING THE AFTER-SALES SERVICEIF AFTER THE ABOVE CHECKS THE FAILURE STILL OCCURS, GET IN TOUCH WITH THE NEAREST AFTER-S

39EN2a. 2b.1.

4CLEANING & MAINTENANCE ...23EMPTYING THE WATER TANK ...

403a.3b.max 2 cmmax 0.79 inch

41EN4.max 100 cm39 inch12

425.6a.6b... xxx V ~ xx Hz xx A IPX4 EV Dxxxx xxxx xxxx

43EN

400011131629

5ENSAFETY INSTRUCTIONSIMPORTANT TO BE READ AND OBSERVEDBefore using the dryer carefully read, Health and Safety and Use and Care guides.Keep these in

6The last phase of the drying cycle is done without heat (cool down phase), to assure that the laundry stays at a temperature level which is not leadi

7ENImportant:The fuse cover must be retted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement i

8SCRAPPING OF HOUSEHOLD APPLIANCESWhen scrapping the dryer, make it unusable by cutting o the power cable and removing the doors and shelves (if pres

9ENDECLARATION OF CONFORMITYThis appliance has been designed, constructed and distributed in compliance with the requirements of European Directives: