Whirlpool WFG320M0BB Installationshandbuch

INSTALLATION INSTRUCTIONS30" (76.2 CM) FREESTANDING GAS RANGESTable of ContentsRANGE SAFETY...

103. If the rear of the range lifts more than ½" (1.3 cm) off the floor without resistance, stop tilting the range and lower it gently back to th

11If the low flame needs adjusting:1. Turn control knob to the “LOW” setting and remove control knob.2. Insert a small flat-blade screwdriver into the

12Complete Installation1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.2

13To Convert Gas Pressure Regulator1. Open broiler door and remove broiler rack. The gas pressure regulator is located in the back right hand corner o

14NOTE: The range cooktop is equipped with 4 burners: 2 burners are power (front), 1 burner is standard (left rear), and 1 is simmer (right rear).5. P

15To Convert Gas Pressure Regulator1. Open broiler door and remove broiler rack. The gas pressure regulator is located in the back right hand corner o

NOTE: The range cooktop is equipped with 4 burners: 2 burners are power (front), 1 burner is standard (left rear), and 1 is simmer (right rear).5. Pla

2RANGE SAFETYYou can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don'tfollow All

3INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w

4Location RequirementsIMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air. It is the insta

5Cabinet DimensionsCabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (9

6Gas Supply RequirementsObserve all governing codes and ordinances. IMPORTANT: This installation must conform with all local codes and ordinances. In

7Burner Input RequirementsInput ratings shown on the model/serial rating plate are for elevations up to 2,000 ft (609.6 m).For elevations above 2,000

83. Determine and mark centerline of the cutout space. The mounting can be installed on either the left side or right side of the cutout. Position mou

9Complete Connection1. Locate gas pressure regulator in the back of the range. IMPORTANT: Do not remove the gas pressure regulator.2. Check that the