Whirlpool AKZM 784/WH Bedienungsanleitung PDF herunterladen (Seite 16)

EN14

Meat Probe Cooking Function

When the meat probe is inserted, cavity temperature is managed as defined for the selected function but

cooking process finish once the temperature measured reach the estimated meat probe target set by the

customer.

There isn’t a specified menu for the meat probe cooking functions, but is always possible switch from a

traditional function to a “Meat Probe function” This occurs when the meat probe is inserted on.

An acoustic signal sounds when the meat probe is detected, and “PROBE” appears on the display for 3

seconds. The display then shows the current information again.

If the Functions knob is not turned to Standby or Lamp, the display shows the general information on the

cooking functions and the temperature set for the meat probe.

If the meat probe is inserted and detected at the start of a function (quick preheating, grill, special

functions, browning) without probe enabling, cooking will not start until the probe is removed. An alarm

signal occurs and the following message is displayed:

Since the end of cooking depends on the temperature set for the meat probe, a countdown timer cannot

be set for the function, and therefore a cooking function with delayed start cannot be set.

After selecting a cooking function, adjust the oven temperature (at the top right of the display) by turning the

knob +/- and confirming with the key . The value to be set for the meat probe (at the bottom right of the

display) can now be changed: turn the knob +/- and confirm with the key to start cooking. The oven and

meat probe temperature can be changed at any time during cooking. To change the oven temperature, just

turn the knob +/-; to change the meat probe temperature, press the key twice, turn the knob +/- to set the

value and confirm with the key . The meat probe default value is 70°C and can be adjusted with minimum

steps of 1°C.

When the meat probe is detected at the start of or during a function, all the preheating phases are skipped

and the first cooking phase of the selected function is carried out; the lamp stays ON until the meat probe

is removed and no longer detected.

If the probe is removed during operation, the display shows the minutes of cooking and the counter

increases the value until the user stops the function or inserts the meat probe again.

When end of cooking occur the display shows a blinking “END”.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Keine Kommentare

Whirlpool AKZM 784/WH Bedienungsanleitung Seite 16