Whirlpool GTE PLATINUM 27 A++ Bedienungsanleitung PDF herunterladen

INSTRUCTIONS FOR USE

DIAGRAM OF THE APPLIANCE (Fig. 1)

A. Handle.

B. Safety lock (if provided).

C. Gasket.

D. Separator (if provided).

E. Defrost water drain plug.

F. Control panel.

G. Side motor cooling grille.

DIAGRAM OF THE CONTROL PANEL (Fig. 2)

1. Red light: when ashing, indicates an alarm

condition (see paragraph “TROUBLESHOOTING

GUIDE”).

2. Blue light: when lit, indicates that the

“Sensor”

function is active (see paragraph

“Sensor”

function).

3. Green lights: indicate that the product is running

and the temperature has been set.

4. Set temperature button: to adjust the set

temperature and to activate/deactivate fast freeze

procedures.

BEFORE USING THE APPLIANCE

Your new appliance is designed to be used in the

household and similar applications such as:

- kitchen areas in shops, oces and other working

environments

- farm houses

- by clients in hotels, motels, residences, bed &

breakfasts.

The product must only be used to store frozen food,

to freeze fresh food and to make ice.

Regulations require the appliance to be earthed.

The manufacturer declines all liability for

injury to persons or animals and for damage to

property resulting from failure to observe the

above procedures and reminders.

1. After unpacking, make sure that the appliance is

undamaged and that the door closes perfectly,

with the gasket remaining intact. Any damage must

be reported to your retailer within 24 hours after

delivery of the appliance.

2. Wait at least two hours before switching the

appliance on in order to ensure the refrigerant

circuit is fully ecient.

3. Installation and electrical connection must be

carried out by a qualied technician, according to

the manufacturer’s instructions and local safety

regulations.

4. Clean the inside of the appliance before using it.

• Before connecting the appliance to the mains

supply, ensure that the voltage corresponds to

that given on the rating plate located on the rear

of the appliance.

• Electricalconnectionsmustbemadein

accordance with local regulations.

INSTALLATION

• Unpacktheappliance.

• Removethe4spacersinsertedbetweenthe

door and the appliance. (Fig 3)

• Make sure the defrost water drain plug (if provided)

is correctly positioned (E).

• For optimum appliance operation and to avoid

damage when the door is opened, leave a space

of at least 7 cm from the rear wall and 7 cm at the

sides. (Fig 4)

• Fit the accessories (if provided).

SWITCHING ON THE APPLIANCE

• Plug in the appliance.

• The green LED lights up (

“NORMAL”

• The blue LED lights up (

“Sensor”

• The red LED ashes to indicate that the

temperature inside the appliance is not yet

suciently low for food storage. The red LED will

normally switch o within the rst six hours after the

appliance is switched on.

• Place food inside the product only when the red

LED has switched o.

• The blue LED,

“Sensor”

(2), stays on until the set

temperature is reached.

Note: Thanks to the ecient lid seal, the appliance

lid will not re-open easily immediately after closing.

Wait a few minutes before re-opening the lid of the

appliance.

TEMPERATURE ADJUSTMENT

Use the key (4) to select the desired temperature.

To adjust the internal temperature, proceed as

follows:

• Repeatedly press the key (4). Each time the key is

pressed, the set temperature is updated, displaying

the “MIN.”, “NORMAL” and “INTENSIVE”values in

succession.

• Select “INTENSIVE”for a colder storage

temperature.

• With partial loads “MIN.” is recommended: this

setting will optimize energy consumption.

The green lights (3) indicate the selected setting as

follows:

MIN.: less cold temperature

(left light on).

NORMAL: middle

temperature (right light on).

INTENSIVE: very cold

temperature (both lights on).

SHOPPING: Quick Freeze

(both lights on blinking).

See the section “Freezing

fresh food”.

Note: the settings will be saved in the memory

even if a power cut occurs. The time needed for the

temperature inside the freezer to reach the set value,

can vary depending on climatic conditions and the set

temperature itself.

1 2 3 4 5

Inhaltsverzeichnis

Seite 1 - INSTRUCTIONS FOR USE

INSTRUCTIONS FOR USEENDIAGRAM OF THE APPLIANCE (Fig. 1)A. Handle.B. Safety lock (if provided).C. Gasket.D. Separator (if provided).E. Defrost wat

Seite 2

“SENSOR” FUNCTIONThis function will activate automatically in the following cases:• dooropening This function activates every time the opening of t

Seite 3

• It is advisable to leave the appliance connected if left empty even for short periods.• Be careful not to damage the oors when you move the appli

Seite 4

4.AllLEDsareoandtheproductisnotworking. • Is there a power failure? • Is the plug properly inserted in the socket? • Is the electric

Seite 5 - 501940000865

13 4 5268 9CLASE/KLASSECLASSE/CLASS°C °FSN 10 - 32 50 - 90N 16 - 32 61 - 90ST 16 - 38 61 - 100T 16 - 43 61 - 11075019400008651 2 3 4

Weitere Dokumente für Kühl- und Gefrierschränke Whirlpool GTE PLATINUM 27 A++

Um das Dokument anzuzeigen Whirlpool GTE PLATINUM 27 A++ Bedienungsanleitung

Whirlpool GTE PLATINUM 27 A++ Bedienungsanleitung (5 Seiten)

Kommentare zu diesen Handbüchern

Keine Kommentare

Whirlpool GTE PLATINUM 27 A++ Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Kühl- und Gefrierschränke Whirlpool GTE PLATINUM 27 A++ herunter. Whirlpool GTE PLATINUM 27 A++ Instruction for Use Benutzerhandbuch

Inhaltsverzeichnis

Weitere Dokumente für Kühl- und Gefrierschränke Whirlpool GTE PLATINUM 27 A++

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kühl- und Gefrierschränke Whirlpool GTE PLATINUM 27 A++