Whirlpool CSP2860TQ Installationshandbuch PDF herunterladen (Seite 24)

CHANGING TO A 30- OR 60-MINUTE TIMING CAM

You can install the 30-minute or 60-minute timing cam

(shipped with dryer) as follows:

1. Unplug dryer or disconnect power.

2. Unlock control panel. Lift up and rotate out from cabinet.

Control panel will still be attached to cabinet.

3. Use a Phillips screwdriver to loosen (but not remove) timer

mounting bracket screw. Lift up to remove timer assembly

and bracket from cabinet.

4. Turn the timing cam by hand until the V-shaped notch lines

up below the ratchet tooth.

5. Insert a narrow, at-blade screwdriver under the timing cam

near the clock shaft. Gently lift cam straight up and off shaft,

making sure that the V-shaped notch clears the ratchet tooth.

6. Place new cam (hub side down) over clock shaft. Line up at

side of shaft with at side of cam hole. Check that drive lug

is in place.

7. Turn cam until V-shaped notch lines up with ratchet tooth.

8. Press cam down in place on clock shaft. Make sure that

V-shaped notch clears the ratchet tooth.

9. Reattach the timer bracket assembly; then tighten

the screws.

10. Repeat steps for the other timer.

11. Close and lock the control panel.

12. Plug in dryer or reconnect power.

WARNING

Electrical Shock Hazard

Disconnect power before making cam changes.

Failure to follow these instructions can result in death

or electrical shock.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 47 48

Keine Kommentare

Whirlpool CSP2860TQ Installationshandbuch Seite 24