Whirlpool Series 900 Bedienungsanleitung PDF herunterladen (Seite 18)

18

SETTING THE CONTROLS

DELAY

WATER

HEATING

CLEAN

DELAY

WATER

HEATING

CLEAN

LIGHT

RINSE-WASH LATER

RINSE

DRY

OFF

NORMAL

POTS-N-PANS

DELAY

HOURS

HEAVY

2

1

3

4

Adding an item during a cycle

You can add an additional item to the

dishwasher anytime before the Cycle Control

Knob reaches Light. Items added after the

Cycle Control Knob reaches Light may only

be rinsed.

1. Lift up the door latch to stop the cycle.

Wait for spraying action to stop before

opening the door.

2. Open the door and add the item.

Using delay wash

(on some models)

You can set the dishwasher to start a cycle

from 1 to 4 hours later.

1. Press the desired Cycle pad.

2. Press the desired Option pad(s).

3. Turn the Cycle Control Knob clockwise to

the number of hours (from 1 to 4 hours)

you want the dishwasher to delay before

the selected cycle starts.

4. Close and latch the door. The Delay/

Water Heating signal light will come on

until the selected cycle starts.

NOTES:

• You can add items while time is counting

down. Close and latch the door. The Cycle

Control Knob will not advance if the door is

unlatched.

• Rinse-Wash Later and Light cycles cannot

be delayed.

• The Delay/Water Heating signal light will

also come on while the water is heating

during all cycles.

The clean signal light

(on some models)

The Clean signal light will come on when a

washing cycle is complete. To turn it off, turn

the Cycle Control Knob clockwise slightly

until the light goes off.

3. Close the door, but do not latch it. Wait

30 seconds for the air in the dishwasher

to warm up. Doing so reduces the

amount of moisture in the vent when

restarting a cycle.

4. Close the door firmly until it latches. The

dishwasher resumes the cycle.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare