Whirlpool ADG 673 IX Bedienungsanleitung PDF herunterladen

-1-

Chart

START

DELAY

option

ON/OFF

BUTTON

PROGRAMME

SELECTOR

KNOB

(see “Table of

programmes”

below)

START BUTTON

The indicator lights up during operation, flashes when a fault occurs, and goes off

at the end of the programme.

START BUTTON RESET FUNCTION:

Press this button for at least 2 seconds; the selected programme and options will

be cancelled. Main failure displays (repeated flashing of the START indicator lamp)

can be cancelled by RESETTING. Detailed instructions are given in chapter

“What to do if...”.

(see at right for options description)

HALF

LOAD

option

1) Programme data obtained in conformity with European standard EN 50242, obtained under normal conditions

(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible

with sensor programmes as a result of the appliance’s automatic calibration system.

2) Reference programme for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: fo

detailed information on the EN/Standard loading comparison test and other tests, contact the following address:

“[email protected]”.

Table of programmes

Deter-

gent

Consumption

Programmes

Available

options

Loading instructions Litres kWh

Minutes

Pre-Wash cold

Delay Crockery to be washed later. — 5.0 0.02 14

Quickwash 40°C

Delay

Lightly soiled crockery, with no

dried-on food. * Use of

tablets not recommended.

X * 13.0 0.70 30

Eco

50°C

Delay

Half load

Normally soiled crockery.

Energy saving programme with

prolonged drying cycle.

X 16.0 1.05 195

Daily 60°C

Delay

Half load

Normally or heavily soiled

crockery.

X 16.0 1.35 120

Intensive 70°C

Delay

Recommended programme for

heavily soiled crockery,

especially suitable for pots and

pans.

X 17.0 1.65 145

DELAYED START

BUTTON

Press the button

(repeatedly) to delay the

start of the programme by

3, 6 or 9 hours.

Then press the START

button. The dishwasher

will start at the set time.

5019 396 01779ADG 673

SALT INDICATOR

When lit, the salt reservoir needs

to be refilled.

Options and display description

BEFORE USING THE APPLIANCE FOR THE

FIRST TIME CAREFULLY READ THIS QUICK

REFERENCE GUIDE AND THE ASSEMBLY

INSTRUCTIONS! THE GUARANTEE IS NOT

APPLICABLE IF FAULTS ARE CAUSED BY

INCORRECT USE OF THE APPLIANCE.

HALF LOAD

The half load cycle can be

used for the upper or

lower rack.

Select the required

programme then press the

“Half load” button. The

light comes on and goes

off at the end of the

programme.

This function can be used

with the programmes

marked with the relative

description in table.

RINSE AID INDICATOR

When lit, the rinse aid dispenser

needs to be refilled.

Quick reference guide

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - 5019 396 01779ADG 673

GB -1-ChartSTARTDELAYoptionON/OFFBUTTONPROGRAMMESELECTORKNOB(see “Table of programmes” below)START BUTTONThe indicator lights up during operation, fla

Seite 2 - First time use

GB -2-First time use1- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the panel9- filters10-

Seite 3

GB -3-Daily check ELSSELELSELS123Adding rinse aid (not necessary when you use tablets). How to adjust the rinse aid dosage regulatorDaily useThe salt

Seite 4 - How to load the racks

GB -4-How to load the racksHJ(depending on the model)G - Foldable plate holders: They can be folded down to load potsorH- Fixed plate holdersI - Cutle

Seite 5 - • Press the START button

GB -5-Rectifying minor faults yourself ...Switch off the appliance Everything o.k. ...Wash cycleSelect programmeQuick, permanent or alternating109678O

Seite 6 - What to do if

GB -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faul

Seite 7

GB -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit- Use tablets for soft water. - Set “Detergent type”

Seite 8

GB -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap.Contact the Af