Whirlpool WEGA25H0HZ Installationshandbuch PDF herunterladen (Seite 21)

4. Remove two screws from the bake burner.

5. Slide the front of the bake burner to the side to remove

tab from front of oven. Lift the back of the bake burner off

the oven oriﬁce, and set the bake burner aside. Do not

disconnect the wire.

A. Bake burner

B. Screws

A. Oven oriﬁce

6. Apply masking tape to the end of a 3/8" (9.5 mm) nut driver

to help hold the gas oriﬁce spud in the nut driver while

changing it. Press nut driver down onto the gas oriﬁce spud

and remove by turning the propane gas bake burner oriﬁce

spud counterclockwise to remove. The spud will be stamped

with a “56.”

7. Replace the “56” spud with a “47” spud. Install the Natural

gas bake burner oriﬁce spud, turning it clockwise until snug.

IMPORTANT: Do not overtighten.

A. Oriﬁce spud

8. Position the back of the bake burner over the oven oriﬁce,

and then align the holes for the screws.

9. Reattach the bake burner with two screws.

10. Position the front of the oven bottom panel toward the front

frame, and then lower the rear of the oven bottom panel into

the oven.

11. Reattach the oven bottom panel with two screws and

two washers.

To Convert Oven Broil Burner (Propane Gas to

Natural Gas)

1. Remove 1 screw from the broil burner.

2. Remove the ﬂame spreader.

3. Remove the broil burner from the broil burner oriﬁce hood.

NOTE: The broil burner will hang in the back of the oven

while you are changing the oriﬁce hood.

A. Broil burner

B. Flame spreader

C. Screws

D. Oriﬁce hood

4. Apply masking tape to the end of a 3/8" (9.5 mm) nut driver

to help hold the gas oriﬁce spud in the nut driver while

changing it. Press nut driver down onto the gas oriﬁce spud

and remove by turning the propane gas broil burner oriﬁce

hood counterclockwise to remove. The hood will be stamped

with a “100.”

5. Replace the “100” hood with a “155” hood. Install the

Natural gas broiler burner oriﬁce hood, turning it clockwise

until snug.

IMPORTANT: Do not overtighten.

A. Oriﬁce hood

6. Place the broil burner on the broil burner oriﬁce hood. Insert

the broil burner ceramic igniter in the hole in the rear of the

oven.

7. Replace the ﬂame spreader with all four tabs facing up and

the notches toward the rear of the oven.

8. Position the broil burner against the top of the oven and

attach it with one screw.

x.xx

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

Whirlpool WEGA25H0HZ Installationshandbuch Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Herde Whirlpool WEGA25H0HZ