Whirlpool GSXK 5020 SD Bedienungsanleitung PDF herunterladen

EN-1-

Bauknecht is a registered trademark

Chart

(see at right for options description)

PROGRAM SELECTION

BUTTON

Push “Programs” button

(repeatedly) until the indicator

of the required program lights

up (see “Table of programs”

below).

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute.

If pressed when the dishwasher is switched off it

drains any possible liquids from dishwasher

(1 minute process).

If the indicator flashes repeatedly, see page 6 -

chapter “What to do if...”.

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the

program. When the door is opened during a

washing cycle, the cycle is temporarily paused: the

Start indicator blinks.

To resume the cycle push the Start button and

close the door within 3 seconds.

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional options) and may

vary depending on additional options or conditions of inlet water parameters, loaded dishes, etc.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/

Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

* Power consumption in: Left-on mode: 0,5 W / Off-mode: 0,5 W.

Table of programs

Deter-

gent

chamber

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

C D

Litres kWh

Minutes

Pre-Wash cold

Delay Crockery to be washed later. — — 4.0 0.03 14 NO

Fast Everyday 60°C

Delay Normally soiled crockery. X X 10.0 1.30 80 Full

Bio Normal

50°C

Delay

Normally soiled crockery. Standard

Program the most efficient in terms

of its combined energy and water

consumption.

X X 12.0 1.02 170 Full

Intensive 70°C

Delay

Recommended program for heavily

soiled crockery, especially suitable for

pans and saucepans.

X X 14.0 1.60 145 Full

Half Load 50°C

Delay

Ideal for washing a half load of lightly

or normally soiled crockery.

X X 7.5 1.00 80 Full

5019 400 00299

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

SALT INDICATOR

When lit (at the end of the

cycle), the salt reservoir

needs to be refilled.

RINSE AID INDICATOR

When lit (at the end of the

cycle), the rinse aid

dispenser needs to be

refilled.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

DELAYED START

BUTTON

The wash cycle can be

programmed to start

after 2, 4 or 8 hours.

Then press the Start

button. The wash

program will start after

the set time.

TABLET SETTING

This setting allows to optimize the cycle performances

according the type of detergent used.

Push the Tablet button for 3 seconds (until the indicator

lights up) if you are using the combined detergents in

tablet (rinse aid, salt and detergent in 1 dose).

If you are using powder detergent or liquid detergent,

the Tablet indicator on the control panel has to be off.

Quick reference guide

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - 5019 400 00299

EN-1-Bauknecht is a registered trademarkChart(see at right for options description) PROGRAM SELECTION BUTTONPush “Programs” button (repeatedly) until

Seite 2 - Daily check

EN-2-First time use5 78614109231- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pane

Seite 3 - Daily use

EN-3-Daily check3Check the rinse aid indicator to check the level into the dispenser.Rinse aid indicator on the control panel Rinse aid indicator on t

Seite 4 - How to load the racks

EN-4-How to load the racksCDD - OPENLOWER RACK4A - Adjustable 2 flaps: in horizontal position for cups / long utensils / stemmed glasses.B - Cutlery b

Seite 5 - Maintenance and care

EN-5-Switching off the appliance. Everything OK...Wash cycleSelect program678Maintenance and careMaintenance and careOverview of programsThe max. poss

Seite 6 - What to do if

EN-6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most faults

Seite 7

EN-7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option;

Seite 8

EN-8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the Af